BPI Slug Loading Manual

[tom357mag]

Does anyone have a copy of this that they could look at and get me the load data for Unique and the:

LBC BluForce Sabot Package 12ga (25/pak)

Just the essentials for 25 great slug loads:
25 Cheddite MultiHulls (new & primed; ready to fold or roll crimp) + 25 BluForce Sabot Slugs. Includes loading data.

The LBC BluForce Sabot’s segmented design incorporates a shock-absorbing cushion section and a multiple-point gas seal system. This creates a more efficient seal, improving load velocity and consistency, which translates into superior long-range accuracy.

Energy damping crush-sections absorb setback forces, enabling the projectile to stabilize earlier in the propulsion cycle. The DGS projectile is engineered for in-flight stability and maximum penetration.

Complete Loading instructions and data for the BluForce Sabot slugs is found in BP's Slug Loading Manual.

Thanks
Tom

 

[rg1]

3rd Edition BPI Slug manual:
7/8 oz LBC Blueforce Sabot Slug
--Cheddite MultiHull--Fio-616 primer--Bullseye 23 grains--9970psi--1450 fps
--Cheddite MultiHull--Ched 209 primer--Red Dot 24 grains--10600psi--1475fps
--for 2 3/4" hulls with a roll crimp (NOT FOLD)
That's the only loads listed for Cheddite hulls in 2 3/4 hulls. There are no loads listed for the LBC Blueforce Sabot slug in 2 3/4-3"-3 1/2" hulls using Unique powder. Federal hulls and LBC slugs were tested with Clays and Titewad powder with Fed 209A primers and a fold crimp. Fiocchi hulls with a ROLL crimp were tested with Clays, Green Dot, Int'l Clays, Longshot, Red Dot, and Titewad all with Cheddite 209's or Fio-616 primers. Rio hulls with the LBC slug and a FOLD crimp were tested with Int'l Clays, Titewad, and Clays all using Rio 209 primers. There are loads listed with 3 and 3 1/2 hulls with the 7/8 oz. LBC Blueforce Sabot slug, just none with Unique. Hope this helps. Maybe a call to BPI would help?

 

[tom357mag]

Thank you