Burris Zee Ring Insert?

[David Sours]

Ok, got the new scope today along with my Burris Zee Rings. The 30 mm rings came with one set of 0 Inserts and 1 set of 10 Inserts Two +10 and two -10. So this is how I installed the scope and rings with the hope to get 20 MOA. Please tell me if I am wrong. In the scope ring @ the rear I put the +10 at the bottom and the -10 at the top per the directions. Then on the front ring I put the -10 on the bottom and the +10 on the top. Is this correct and am I right in thinking that I will get an additional 20 MOA in elevation?

If so when I bore sight the rifle should I have to move the elevation of the scope down, to get the zero?

Thanks,
David

 

[browningguy]

You are correct, as to which way to adjust, no way to know that until you give it a try.

 

[David Sours]

Thanks for the confirmation. Hopefully the wind will lie a little and I am headed to the range tomorrow to zero it in. Then we will know for sure.

Thanks,
David