red95gtcoupe
Member
- Joined
- May 25, 2009
- Messages
- 15
I am trying to run .308 brass through my lee full length resizing die and they keep getting stuck when they get about 1/4-1/2'' from the base. I set the die height according to Lee, the brass has been cleaned and I have even tried to wipe each case individually. I use One Shot lube and have tried everything from just spraying it on to rubbing it around with my fingers making sure the whole case is lubed. Ive let it sit like the instructions say and even tried when a little wetter and even waited a little longer. The brass is RP and the press is a Lee turret. Any ideas? I am new to reloading but have gone through the Lee and Lyman manuals, plus read a ton before starting. I have reloaded .223 with the 2 die RCBS sets and it went perfectly smooth. The Lee was part of the pacesetter die set.
thanks
Brian
thanks
Brian