I recently purchased a CETME parts kit from Cheaper Than Dirt. It was only $10 for a fore stock, two butt stocks three hand grips, and misc parts. In the same order, I ordered their used green G3 butt stock, handgrip and fore stock, which also ran for $10.
The reason I bought the CETME parts is that I like wooden furniture. The fore stock from the CETME fits the HK91 just fine. The CETME butt stock also fits in the G3 buffer/recoil spring assembly, as long as the buffer hasn't been installed. But the butt stock buffer hole on the CETME stock is about 2mm higher than the HK buffer hole.
Has anybody ever modified a CETME stock to fit on a 91? It seems to me that if I just chisel out some of the wood to make room for the HK buffer, it should work. Does anybody have any advice before I begin chopping? I figured it was nice of CTD to include two butt stocks, in case I mess up too badly on one of them.
The reason I bought the CETME parts is that I like wooden furniture. The fore stock from the CETME fits the HK91 just fine. The CETME butt stock also fits in the G3 buffer/recoil spring assembly, as long as the buffer hasn't been installed. But the butt stock buffer hole on the CETME stock is about 2mm higher than the HK buffer hole.
Has anybody ever modified a CETME stock to fit on a 91? It seems to me that if I just chisel out some of the wood to make room for the HK buffer, it should work. Does anybody have any advice before I begin chopping? I figured it was nice of CTD to include two butt stocks, in case I mess up too badly on one of them.