DoubleTapDrew
Member
Whats the best way to remove the stock trigger guard on an AR-15 (LMT lower)? I picked up a magpul enhanced guard to install. The front was no problem but the rear roll pin is in there good. I got a standard punch set from the hardware store and 1/8" is the proper size I believe, but I don't want to hammer on it too hard and bugger up the roll pin and end up having to drill it out or egg the hole. Light taps with a deadblow hammer on the punch aren't budging it. Do I need a special roll pin punch or can this be done without one?
Seems this should be easier to do than it's going!
Seems this should be easier to do than it's going!