ZBill
Member
- Joined
- Sep 12, 2004
- Messages
- 397
When I took my Series 70 9mm Govt Model apart for cleaning I was unable to remove the extractorat first. It appeared the hook was catching on the frame. I pushed the hook toward the center of the extractor tunnel while pulling on the end of the extractor and I was able to get it out.
I cleaned the extractor and tunnel and now find it difficult to push the extractor all the way back in with out a lot of pressure. I don't recall this problem the last time I cleaned it. (The last time I fired it was with Wolf ammo but a don't see how this would cause a problem).
My question is should the extractor easily slide in its full length back into the tunnel? If so I guess I need to straighten it out a bit. It must be "mis-tuned".
I appreciate any input. Thanks, Bill
I cleaned the extractor and tunnel and now find it difficult to push the extractor all the way back in with out a lot of pressure. I don't recall this problem the last time I cleaned it. (The last time I fired it was with Wolf ammo but a don't see how this would cause a problem).
My question is should the extractor easily slide in its full length back into the tunnel? If so I guess I need to straighten it out a bit. It must be "mis-tuned".
I appreciate any input. Thanks, Bill