cherryriver
Member
I think I've seen posts that go around this one, but I can't say I've seen the one that is just what's going on with my Officer-sized Para Companion LDA.
The empties leave the gun, apparently properly, but a fair number of time, the last one before slide lock ends up with the case mouth crushed in in two places, 170 degrees apart. It's so striking that I've actually stood there and taken note of the bent brass being specific to the last round.
If it happens with different kinds of ammunition, I haven't noticed.
This is one with a later (2005) PXT slide.
The gun runs fine and I trust it, but this just can't be right.
What the heck?
Bill
The empties leave the gun, apparently properly, but a fair number of time, the last one before slide lock ends up with the case mouth crushed in in two places, 170 degrees apart. It's so striking that I've actually stood there and taken note of the bent brass being specific to the last round.
If it happens with different kinds of ammunition, I haven't noticed.
This is one with a later (2005) PXT slide.
The gun runs fine and I trust it, but this just can't be right.
What the heck?
Bill