Custom Glock 20L Project
This started out as a used Gen 3 G20SF which I paid $600 for. It came with about 80 rounds of ammo, and extra LWD barrel and 2 holsters.
After I shot the gun, I knew I had to do the Long Slide conversion so I sold the complete factory slide assembly and the extra barrel for $525.
So I really only paid about $75 for a Gen 3 G20/21SF frame. I eventually used the Gen 3 frame on a Gen 2 G-21. I did this because I wanted the Gen 2 frame for the G20L project.
The first phase was getting the long slide, for that I went with Bobby Carver.
He built the slide from the following parts for less the $630:
Once I received the slide from Bobby I realized that the Bull Nose profile on the front of the slide looked horrible with a comp sitting in front of it. Here is a picture of it:
So I had a friend fill in the bull nose with TIG weld and then I machined it square.
After I got that staright I ordered a C-More STS scope for $302 shipped. I was a perfect fir for this wider 10mm slide
I did really know who I would pay to do the final mods but after a little research I went with Mark at L&M Precision Gun Works.
He did all of the following work:
I am extremely happy with it and the pictures do not do it justice.
I can not wait to shoot this thing. Unfortunately all of the ranges are closed for Christmas but hopefully I be able to get to one after the first of the year.
This started out as a used Gen 3 G20SF which I paid $600 for. It came with about 80 rounds of ammo, and extra LWD barrel and 2 holsters.
After I shot the gun, I knew I had to do the Long Slide conversion so I sold the complete factory slide assembly and the extra barrel for $525.
So I really only paid about $75 for a Gen 3 G20/21SF frame. I eventually used the Gen 3 frame on a Gen 2 G-21. I did this because I wanted the Gen 2 frame for the G20L project.
The first phase was getting the long slide, for that I went with Bobby Carver.
He built the slide from the following parts for less the $630:
- Lone Wolf 10MM Long Slide, Blind Marked
- Lone Wolf 6.61" Threaded Barrel
- CARVER Custom 10MM Comp
- Glock Internal Slide Parts
- Engraving
- CARVER Custom SS Guide Rod Assembly
Once I received the slide from Bobby I realized that the Bull Nose profile on the front of the slide looked horrible with a comp sitting in front of it. Here is a picture of it:
So I had a friend fill in the bull nose with TIG weld and then I machined it square.
After I got that staright I ordered a C-More STS scope for $302 shipped. I was a perfect fir for this wider 10mm slide
I did really know who I would pay to do the final mods but after a little research I went with Mark at L&M Precision Gun Works.
He did all of the following work:
- Timed the comp to the barrel
- Machined the sides of the comp to match the barrel
- Machined the rear of the slide for the C-More STS Scope
- Ball milled the grove on the top of the slide that goes from the front of the slide and extends into the comp.
- Machined the top hole to make the ends round instead of square-ish
- Chamfered the bottom edges of the slide and the comp to make them match
- Drilled 2 additional holes on the bottom of the slide, one on the comp and one behind the factory front sight hole
- Machined the top of the barrel to remove the last traces of the LWD logo and then he polished it
- Cerakoted the slide graphite black
I am extremely happy with it and the pictures do not do it justice.
I can not wait to shoot this thing. Unfortunately all of the ranges are closed for Christmas but hopefully I be able to get to one after the first of the year.