[email protected]
Member
- Joined
- Dec 9, 2006
- Messages
- 23
I'm new here and new to reloading. Bought Dillon Sq. Deal, loaded 300 rounds 40 cal. no problem. Just purchased 380 dies from dillon, will not flare case enough to seat bullet. Magtech Brass,Rainer copper clad 95 grain bullet.
It seems that once the powder die is set up according to the manual (so that the powder bar reaches the end of it's travel as the handle bottoms out) there is very little ajustment that can be made to case flare by screwing die in, before the machine is out of ajustment too the point it wants to push powder measure off the die.
I have an E-mail in to Dillon, but when I found this forum I was hoping someone else had solved this problem? It won't load 380 with out the bullet being on an angle or some of the brass plating being pushed outside of case.
Thanks Carl
It seems that once the powder die is set up according to the manual (so that the powder bar reaches the end of it's travel as the handle bottoms out) there is very little ajustment that can be made to case flare by screwing die in, before the machine is out of ajustment too the point it wants to push powder measure off the die.
I have an E-mail in to Dillon, but when I found this forum I was hoping someone else had solved this problem? It won't load 380 with out the bullet being on an angle or some of the brass plating being pushed outside of case.
Thanks Carl