emmie
Member
I'm full sizeing 380 cases and am getting a ripple of brass as I push case into die. this ripple is ironed out after case has been sized,but have never run into this befor in any other caliber.
the brass that this happens with,most of time has a bulge in one side of it. like 45acp brass that has no support at the base of the ramp. the 380 bulge is up about 1/2 way length of brass.
is this a weak spot,subject to rupture and sepperation? over worried?
all suggestions and info welcomed
thank you for your time-
emmie
the brass that this happens with,most of time has a bulge in one side of it. like 45acp brass that has no support at the base of the ramp. the 380 bulge is up about 1/2 way length of brass.
is this a weak spot,subject to rupture and sepperation? over worried?
all suggestions and info welcomed
thank you for your time-
emmie