upi44
Member
Hey guys I need I little help with setting up myHornady
lnl ap for .40 cal sw
Here is my setup
Station 1 EGW U-Die
Station 2 CAPD w/ Powder thru expander
Station 3 powder cop (hornady)
Station 4 Hornady seating die. no microjust it is on order
Station 5 Hornady Taper Crimp
Problems
1. The egw was too short so I took of the lock nut and screwed it way down. Does this sound right? Is there a better solution??
2. The CAPD/expander is screwed all the way down and does not bell the case very much and the die is so low it hits the shell plate before the other dies have a chance to do what they need to do
3. Bullet is not seating far enough down in the case the die and bullet seater dial is screwed in as far as they will go. Also the CAPD is hitting the shell plate before the seater has gone all the down into the case.
It seems like most of the dies are too short ????
lnl ap for .40 cal sw
Here is my setup
Station 1 EGW U-Die
Station 2 CAPD w/ Powder thru expander
Station 3 powder cop (hornady)
Station 4 Hornady seating die. no microjust it is on order
Station 5 Hornady Taper Crimp
Problems
1. The egw was too short so I took of the lock nut and screwed it way down. Does this sound right? Is there a better solution??
2. The CAPD/expander is screwed all the way down and does not bell the case very much and the die is so low it hits the shell plate before the other dies have a chance to do what they need to do
3. Bullet is not seating far enough down in the case the die and bullet seater dial is screwed in as far as they will go. Also the CAPD is hitting the shell plate before the seater has gone all the down into the case.
It seems like most of the dies are too short ????