Hi-Point 9mm carbine

[marineshooter]

hello I just got a Hi-point 9mm carbine. put 200 rounds thru it with just a few ftes with blazzer brass 115 gr fmj. dead on and fun to shoot. With the longer barrel how will 115 gr lrn reloads shoot, will they lead bad.

 

[Kp321]

Several factors have an effect on leading, barrel condition, lead hardness, velocity, bullet diameter, etc. I don't know how smooth Hi-Point bores are so that is a major factor. Don't try to hot rod your loads with lead, try plated bullets. Priced between lead and jacketed, they are an economical alternative.

 

[Duckdog]

You can shoot lead out the hi point. I do it quite a bit without issue. Just make sure you have a good lube and you'll be OK.

 

[Walkalong]

You should be fine. Worse case scenario is you have to adjust your load a little.

 

[Marlin 45 carbine]

a slug with a diameter a couple thous over groove size likely will do better.

 

[H&R Glock]

Hi Marine, this old swabbie shoots plated 115 grain bulets and some lead. I have had no problems with leading. Keep all the velocities down to 1000 or 1100 fps.
The gun is definately a "fUN Gun" but is also an UGLY gun. I wish someone would make an after market black stock that looks good!

 

[jfremder]

125gr MB SmallBall over 6.0 gr Blue dot was a great load for my 995TS

 

[45lcshooter]

I had one in 40sw. It shot everything i put in it, fmj, lead. No problems, so i would assume you would be ok as well with the 9mm.

 

[marineshooter]

Thanks everyone for the replys. I will go out to the range and see how it goes.