Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
You are using the old Black Responsive theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.
I've seen that sort of migrating fouling create extraction issues when it eventually caused congealed fouling to build up between the extractor (behind the hook) and the inside of its recessed slot.
I'll give the extractor a thorough cleaning, I'll just remove it and see if there's excessive build up behind it. I clean my guns after every range trip and some solvent and oil probably found it way into the extractor slot. It's possible my chronograph is reading fast and my reloads are a bit underpowered, so ill just load some hotter rounds for a test run. I'll also get a few recoil springs for spare parts. Thanks for the advice everyone! I'll get this figured out eventually
My HK45 had its first failure after 11K rounds or so and it was an oversized WWB case. Don't remember the length, but it was far from NATO specs.
Check the flat spring; usually it's the first one to break.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.