Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Home Range, need some ideas & imput

Discussion in 'General Gun Discussions' started by Cluster Bomb, Apr 2, 2012.

Thread Status:
Not open for further replies.
  1. Cluster Bomb

    Cluster Bomb Member

    Joined:
    Jul 3, 2011
    Messages:
    297
    Location:
    Maine
    Hello gang. I have posted about making a safe range sometime ago. and many of you were interested in my outcome. It was winter than however due to the warm weather recently I have been able to tackle this.

    the "range" before. Just something to shoot at out back.
    [​IMG]

    The New Range.
    [​IMG]
    The Clay targets on the left wer setup using the example from Maineshooter.com
    The Zombie target on the right was setup using the example from Maineshooter.com

    the setup is as follows.
    (4) pistol "allys" in center
    +Rifles are rarly shot, if at all a pistol cal carbie but seldomly.

    22lr range to the left with its own standing area.
    +22lr has clay targets to shoot at drawn on a rope
    +22lr will have a preassure treated sheet of plywood with holes cut out. Ranging from 2" to the size of a dime. (the smaller, the more points)

    The Zombie lane has a spool setup, which is quite fun to shoot at. this is usually a shotgun lane.

    -----

    Plans:
    I plan on adding more of a barrier to the left where 22s will be shot. I would like to add some sort of roof to where the "table" (rather a spool from an electrical company)

    id like to know what you think, ideas, and other insight of the range.
     
  2. HGM22

    HGM22 Member

    Joined:
    Mar 11, 2010
    Messages:
    732
    I can't tell, do you have dirt behind the log wall?
     
  3. Flintknapper

    Flintknapper Member

    Joined:
    May 11, 2006
    Messages:
    1,928
    Location:
    Deep East Texas
    You'll probably want to spend some time cleaning/clearing out the area in front of the targets.

    It would seem that the "footing" is ...questionable. So just for "safety" sake, a clean (preferably level) place to stand...would be a nice addition.
     
  4. MachIVshooter

    MachIVshooter Member

    Joined:
    Aug 11, 2005
    Messages:
    14,243
    Location:
    Elbert County, CO
    Dense as that forest is, I don't think he needs to worry about it. Doesn't look like a stray bullet could make it 100 yards without smacking a tree.
     
  5. samefly

    samefly Member

    Joined:
    Dec 2, 2011
    Messages:
    28
    Location:
    Texas
    I'd like to eventually have my own range as well (I'm jealous). Has anyone else built a range or have blue prints/designs/photos to share?
     
  6. GWARGHOUL

    GWARGHOUL Member

    Joined:
    Mar 11, 2011
    Messages:
    719
    Location:
    Missouri
    I used to have 13 acres, and beyond that 13 acres was at least another 100 yards before any path of car or man in either direction, and that had trees too.. Was filled with trees even more dense then this fellas'. With that being said, I did not have any issues except maybe spending too much money on ammo, and maybe a bit too much target shooting a little to close to deer season for my neighbors ( a deer steak and a beer settled that for me.. "yeah, no problem.. I'll keep it down to .22's in the week or two before deer season for ya bud.. thats some good steak.. thanks!"

    Depending on how much land you have, you may want to look into getting some clean fill for a backstop. Remember you are responsible for every bullet. This can amount to a lot of responsibility when you have a range of your own. Looks like you're probably good to go though.

    But as another said.. clear that footing, and perhaps level it in time.

    Cool setup.
     
  7. ultradoc

    ultradoc Member

    Joined:
    May 20, 2008
    Messages:
    1,118
    Location:
    Ohio
    Wish I had some land to do this. Samefly, I think the NRA might have some design ideas. Atleast I think they did before.
     
Thread Status:
Not open for further replies.

Share This Page