Just wondering if there were any common or frequent issues with them. I added them to an order from Midway to get free shipping and the order only went up $2.
What is your question? Years ago I bought some of their bullets through Midway I thnk it was for my 327 Fed Mag, They worked fine Company has been around for a long time
I see they now have "slick coat" not sure if that is the same as Polymer coated.
https://hunters-supply.com/356-9mm-115-p-2999.html
This thread probably would have been more valuable if I’d asked before I bought them. Has anyone used these? They seem like they’ll be fine for range practice. I’m planning to use W231 for powder.
Their "Slick Coat" bullets sure are pricey. At $154/1000 + shipping, I rather shoot RMR jacketed bullets.Pricey little boogersI see they now have "slick coat" not sure if that is the same as Polymer coated. https://hunters-supply.com/356-9mm-115-p-2999.html
MidwayUSA ... Hunter Supply 115 Grain Cast 9mm ... W231 ... Hodgden site I’ll probably push these 1100 or less so I should be fine.
I think you will be fine testing some at start-to-mid range load data.I don’t have enough to do a full load development test so I’ll probably do a few at the minimum and a few at the middle of the range.
RMR, Missouri, nor anyone else is going to sell you 250 bullets shipped to your door for 2 bucks.Just wondering if there were any common or frequent issues with them. I added them to an order from Midway to get free shipping and the order only went up $2.
No,none of the three are.Two Sigs and a Springfield.Also are your guns polygonal rifled?