Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

installing wood grip on my cz75 sp01, should i reuse the retaining washer?

Discussion in 'Handguns: Autoloaders' started by minh, Sep 8, 2008.

Thread Status:
Not open for further replies.
  1. minh

    minh Member

    Joined:
    Jul 15, 2008
    Messages:
    27
    factory rubber grip came with the spikey washer, should i reuse that for the wood grip or leave it out and just use the screw??
     
  2. BlindJustice

    BlindJustice Member

    Joined:
    Jul 26, 2007
    Messages:
    2,798
    Location:
    Pullman, WA
    By spikey washer - perhaps it's a self locking washer?

    Is it metal ? just curious.

    Randall
     
  3. minh

    minh Member

    Joined:
    Jul 15, 2008
    Messages:
    27
    yep, self locking washer and it is metal
     
  4. hags

    hags Member

    Joined:
    Jan 21, 2007
    Messages:
    750
    Location:
    Chain o' Lakes, Illinois
    If it fits the wood grip, and most do, then yes, by all means use it.

    Why wouldn't you?
     
  5. burningsquirrels

    burningsquirrels Member

    Joined:
    Apr 1, 2008
    Messages:
    1,562
    Location:
    Georgia
    yes, it's there for a reason.
     
  6. minh

    minh Member

    Joined:
    Jul 15, 2008
    Messages:
    27
    well i figure the self locking washer will dig into the grip and basically carve out the wood? i dunno, maybe im just paranoid i may ruin it
     
  7. hags

    hags Member

    Joined:
    Jan 21, 2007
    Messages:
    750
    Location:
    Chain o' Lakes, Illinois
    It's supposed to "dig into" the grip to some extent, wood, plastic or rubber.
     
  8. Dos

    Dos Member

    Joined:
    Dec 23, 2003
    Messages:
    61
    It was meant to be used for any grip. Keeps grip screws from backing out. Use It.
     
Thread Status:
Not open for further replies.

Share This Page