Are these a good idea to use on a factory rifle? If so, which or both?
A benchrest guy recommended them to me. My primary goal is to reduce the gun's propensity to copper fouling and *maybe* gain a bit of accuracy as a bonus.
My rifle (TC Icon) is plenty accurate, hovering around MOA overall with nine different factory loads.
However, I swear I cannot get all of the copper fouling out of it. I recently tried an entire week of Boretech Eliminator sessions (including leaving it overnight in the bore a few times). It was still showing signs of fouling. I'm using a bore guide, plastic jag, plastic patch puller and nylon brushes, no less. In other words, I'm not getting false indications from the brass involved.
A benchrest guy recommended them to me. My primary goal is to reduce the gun's propensity to copper fouling and *maybe* gain a bit of accuracy as a bonus.
My rifle (TC Icon) is plenty accurate, hovering around MOA overall with nine different factory loads.
However, I swear I cannot get all of the copper fouling out of it. I recently tried an entire week of Boretech Eliminator sessions (including leaving it overnight in the bore a few times). It was still showing signs of fouling. I'm using a bore guide, plastic jag, plastic patch puller and nylon brushes, no less. In other words, I'm not getting false indications from the brass involved.