I just pulled the trigger, so to speak, and ordered a 4 cavity mold from Tom at Accurate Molds. It's the .45-200S. I'll be sending it off to Erik at Hollow Point Mold Service to make it in to one of his inset-bar HP molds. All that should take a few weeks but I'll post the results.
Erik is also going to make a seating jag for my cylinder loader that mirrors the HP of the bullet so it centers and holds it straight. Between that and the heel it should load very easily indeed.
I'm also thinking about changing the front sight on my ROA to a barrel banded ramp with a patridge brass blade. I always liked the way a barrel band sight looked on a revolver. We'll see if it's do-able.
Erik is also going to make a seating jag for my cylinder loader that mirrors the HP of the bullet so it centers and holds it straight. Between that and the heel it should load very easily indeed.
I'm also thinking about changing the front sight on my ROA to a barrel banded ramp with a patridge brass blade. I always liked the way a barrel band sight looked on a revolver. We'll see if it's do-able.