Less than half an inch Picatinny riser--Is there such an animal?

[Arizona_Mike]

I'm trying to get scope, BUIS, and Laser on a short bullpup rail. I have a good light already integrated into the forward grip and no room for a laser below.

If I had a Picatinny riser taller than 0.280" (from top of rail to top of riser) I could clear the folded BUIS. It could be no more than 0.394" tall in order for the laser to fit under the scope. Preferably no more than 0.324" tall to allow me to get a scope cover of flip up cap on the scope.

Basically a 5/16" or 8mm riser would be perfect.

This 0.300" Riser would work for height but is way to long. I need about 1.5-2" in length; 2.15" max.

Mike

 

[Odd Job]

I have two of these Yankee Hill Machine risers:

http://yhm.net/scope-riser.html

Very nicely made, just beware they don't side-clamp, you have to feed it onto the rail from the front or back.

 

[Odd Job]

Ah, I see it will be too long even if you cut off the overhang.

 

[Odd Job]

How about this, too short?

http://yhm.net/mini-riser.html

 

[Arizona_Mike]

How about this, too short?

http://yhm.net/mini-riser.html

Both of the risers you linked to are 0.500" tall. I need a riser that is less than 0.394" tall. I have an almost identical riser to this second one from another company and the laser does not fit under the scope. The length is good.

Mike