Ignition Override
Member
The barrel which came with the original WW2 slide fed perfectly, but apparently the feed ramp had been machined. All the ejected brass had bulges
(I never checked brass until after thirty rds.). Not good.
A seasoned WW2 German handgun guy said the brass was "unsupported" by the shape of the feed ramp.
The new barrel supports the brass-no bulges at all. This other feed ramp has a smoother contour than the problem ramp.
When the new barrel is used in the previous slide or the slide which came with the replacement barrel, the slide jams as soon as the magazine is inserted. It should slam fully fwd. Both slides have equally tight springs.
Each ammo round is pushed only part way fwd. in the feed lips, then (of course) it stops the slide from closing. Happens very often. The rounds are Not stovepiped in the normal sense, they are mostly even with the top of the magazine. The ramp is shiny and fairly clean. The magazine is always fully seated. Any ideas?
(I never checked brass until after thirty rds.). Not good.
A seasoned WW2 German handgun guy said the brass was "unsupported" by the shape of the feed ramp.
The new barrel supports the brass-no bulges at all. This other feed ramp has a smoother contour than the problem ramp.
When the new barrel is used in the previous slide or the slide which came with the replacement barrel, the slide jams as soon as the magazine is inserted. It should slam fully fwd. Both slides have equally tight springs.
Each ammo round is pushed only part way fwd. in the feed lips, then (of course) it stops the slide from closing. Happens very often. The rounds are Not stovepiped in the normal sense, they are mostly even with the top of the magazine. The ramp is shiny and fairly clean. The magazine is always fully seated. Any ideas?