Mountain Gun Shoulder Rig

Status
Not open for further replies.

Eaglestroker

Member
Joined
Feb 21, 2011
Messages
455
Location
Southaven, MS
Ray Cory, otherwise known as Lobo Gun Leather, was kind enough to provide me with the pattern for this ingenious shoulder piece sometime back after a discussion on the subject. Fast forward some two years and I finally had a chance to put it into use not long ago.

The idea behind this rig is something to wear in the deer stand, on a four wheeler, horse, and otherwise just knocking around situations where I like to have a gun and prefer to have it off my belt. Certainly not a speed rig to deploy.

Straps are two layers of 3 oz veg tan lined that need to be shortened by 8-10" OAL to minimize the bulk. The butterfly panel is 8oz with a 4oz back panel, sheath is a lined double 3oz back with 6oz welt and 8oz front, along with a double 10oz holster and 8oz ties/water loops all around. With all the individual pieces it totals out at 23 pieces of leather and another 24 pieces of hardware! The stitch lines on this holster need to be critiqued along with a bit of cant to offset a negative cant from how it sits on me - but otherwise a very serviceable rig.

I've been wearing this a few days a week for around a month and it conceals well under a light jacked for me. May be another month before I get the harness to set just 'perfect' though :D



DSC_0847_zpsa1f06270.gif
DSC_0850_zpsca4a807b.gif
DSC_0858_zps3f80b5aa.gif
DSC_0861_zps266262bc.gif
 
Looks great. If it were me, I'd think about adding a way to carry ammo on the knife side. Maybe just loops.

I like being able to carry different loads ie snakeshot etc. with a revolver.
 
Jdub: I've been thinking about something to go with the knife for just that, just have to find the time!

Craig: Not much of anything productive :) things are starting to ease up though.
 
Status
Not open for further replies.
Back
Top