Nature Boy
Member
- Joined
- Apr 21, 2015
- Messages
- 8,294
Up until recently, I've FL sized everything. Once I bought some expensive (Lapua & Nosler) brass I decided I'd try to get a bit more life out of them and try neck sizing. I picked up an RCBS neck sizing die and set it up per the instructions.
My understanding is the neck sizer only adds tension back to the neck and doesn't affect shoulder dimension or headspace, correct?
I've also noticed that my WFT trimmer which was set up to trim to 2.005 on FL sized brass, needs to be adjusted now to accommodate neck sizes cases since the WFT locates off the shoulder. I assume that makes sense and is normal?
Trying to be cautious here as this isn't range pick up brass and I don't want to scrap any due to a bone head mistake
My understanding is the neck sizer only adds tension back to the neck and doesn't affect shoulder dimension or headspace, correct?
I've also noticed that my WFT trimmer which was set up to trim to 2.005 on FL sized brass, needs to be adjusted now to accommodate neck sizes cases since the WFT locates off the shoulder. I assume that makes sense and is normal?
Trying to be cautious here as this isn't range pick up brass and I don't want to scrap any due to a bone head mistake