New SIG P210 Target

[Rock185]

I've not had any parts break or fall off my American SIG, but agree the target grips are a bit much. I replaced mine with some more service style Walnut grips from Hogue.

 

[Master Blaster]

So I found the sight is snug when pushed into place.
I cleaned and added a small drop of loctite 262. Let it sit overnight. Yesterday I fired 100 rounds and the sight didn't budge. So good for now as I may put a different front sight on anyway.


.

 

[Otto]

Next time, use Loctite 620. It's high strength and high temperature. That makes it better resistant from the heat of the barrel. It's what Dawson Precision uses on their sights.

 

[SwampWolf]

agree the target grips are a bit much.

I think they're fine, so long as you're shooting targets with it at the range. Too bulky for almost any other use.

 

[Mark_Mark]

I wish they made the Sig P210 in .45

 

[czhen]

I wish they made the Sig P210 in .45

I do believe never was made in .45 cal.
Which was mostly an American cartridge.
Same factor for Lugers only for U S Army trials