New Sig P220 TB combat shoots way low...fixes??

[CDignition]

...Besides replacing the entire front sight??.. It has Tritium sights on it(High Suppressor Sights fyi), I could get a blank and install it, then tweek it to shoot right, then ill have to send it out and have a Tritium vial installed.....

Thats alot of pain...does Sig offer different height fronts for adjusting these??

 

[AndyC]

What bullet-weight are you using, and at what distance? If you're leery of getting a different front-sight, you might want to try a heavier bullet first (if possible). All of this presupposes that you're not flinching the shot low.

 

[CDignition]

230 Gr Ball, 10 yards about 2" low

 

[J32A2]

Have you let anyone else try it? My Combat TB is deadly accurate!

 

[Clipper]

My pt-145 needed to have the front dot occlude the target. A 6 O'clock hold would put it low.

 

[CDignition]

Its the gun, not me,lol... but yes, others have had the same trouble.. I dont like Occluded target sighting...

Ill call Sig to see if they offer any different hight sights...otherwise ill install a larger one and have a Insert installed.

 

[aspade]

Sig factory sights come in different heights both front and rear. See page 16 of the manual, available online here:

http://www.sigarms.com/CustomerService/documents/CLASSICPISTOLOM.pdf

 

[10-Ring]

Sounds like a simple sight replacement is all you need -- and you can put the sights you prefer in the process -- win win

 

[CDignition]

Well, Duh,lol... If all else fails, read the directions. Ill check the heights of the ones I have and see if they correlate..they are extra high, so I hope they are on the chart.

 

[10-Ring]

Hey -- I'm the master of the obvious