yhtomit
Member
UPDATE: My lower arrived, and Bill Savage (Bill's Gun Shop, Pipersville, PA) was again supremely helpful and accomodating, offered me no guff for taking advantage of his ultra-cheap FFL service even though I was too low on the funds to buy any of his Garands, ARs, AKs, or 1911s (and I would really like one of the Taurus 1911s). the laser engraving went well -- I was hoping the white would be slightly brighter, but it's well within the expectable range. Jon at Anvil was very responsive as well. Pictures of the lower sometime after my final exams
--------------------------------
I'm excited -- went with Anvil, at the near insistence of many on this board; I'm hopeful that the design I included was successfully laser-engraved on the side, but if it's not, it's still a decent price for an AR lower with parts kit. (just over $200)
I am unlikely to get it all kitted out with those other bits (like, say, a barrel) for a little while, but those bits are now on the list for either this summer in TN, or toward Fall in WA. Of course, if you have tired of your AR bits, are independently wealthy, and eccentric, I do take donations ...
timothy
--------------------------------
I'm excited -- went with Anvil, at the near insistence of many on this board; I'm hopeful that the design I included was successfully laser-engraved on the side, but if it's not, it's still a decent price for an AR lower with parts kit. (just over $200)
I am unlikely to get it all kitted out with those other bits (like, say, a barrel) for a little while, but those bits are now on the list for either this summer in TN, or toward Fall in WA. Of course, if you have tired of your AR bits, are independently wealthy, and eccentric, I do take donations ...
timothy
Last edited: