Rainier 165Gr Plated 40 S&W load needed

Status
Not open for further replies.

JCC77

Member
Joined
Aug 22, 2014
Messages
6
I have 500 Rainier copper plated 40 S&W bullets that are 165 grain RNFP. I have tried for months to find a load but I have been unsuccessful. Does anyone have a load for this with the C.O.L.??? Please help.

Thanks,
 
what powder are you using , most powder websites now have load data for 165 gr plated rnfp
 
I was hoping to use either red dot or green dot but I'll take any load with any powder.
 
I also don't know how Rainier plated 165gr RNFP compare to Xreme plated 165gr RNFP, but I have been using the Hodgdon load data for 165 gr BERB FP without any issues when loading the Xtreme 165gr RNFP bullets. I loaded to a COL of 1.125" and 1.142" using AutoComp.

The Xtreme 165gr RNFP bullet length is between 0.5335" and 0.5360" based on my measurements.
 
Thank you very much gentleman. I really appreciate the info. I can finally load and shoot some of these bullets.
 
Try a longer OAL. Up to 1.145 if it will pass the plunk test.

5.0 WST at 1.125" is a good load for me with 165 plated. So is 5.4 Unique. With Xtreme 165 RNFP, though, not Raniers.

You might look up bds' threads on loading .40 with Promo/Red Dot. 4.0 or thereabouts has been good for me with a few .40 loads. You'll have to find the old Alliant data from 2004 and earlier.
 
I have just loaded some S&W 40 using x-treme 165gr plated RNFP using 5.4grns of PB.
Nice, clean burning medium load. Have fun...........
 
I have loaded the Rainer 165gr FP bullets with, Titegroup, HS-6 & Longshot. I used Hodgdon's data for Berry bullets with great success. I pushed this bullet to 1300fps out of a carbine with Longshot, I like them a lot.

I think Longshot is my favorite with the plated bullets in .40 and HS6 with lead.
 
I've loaded Xtreme's 165gr RNFP over 6.4gr Power Pistol with OAL of 1.125 with great success out of both a SIG 2022 and Glock 23. A good low/middle-road load with great results.
 
Status
Not open for further replies.
Back
Top