someguy2800
Member
I just wanted to give a shout out to this product because it works so well for my hi point carbine, 9mm 1911, and LC9s single stack mags. I'm sure it would work on most single stack 9mm or 380 mags.
https://www.ebay.com/itm/RangeTray-...dLoader-for-the-Hi-Point-995-9mm/253126668050
here is how it works
below is the review I left on there ebay product page
I was pretty skeptical that this would work bit it really does work slick. Its not the fastest but is the easiest on the hands of any mag loader I've used. This works on my Hi Point 995, Ruger LC9s, and 9mm 1911 mags so great value. It is 3d printed and the material looks like PC-ABS. Only thing that could improve it is if it was about .060" longer or so. With bullet loaded long you have to rock the mag slightly as you push it down to clear the feed lips with the 995 and 1911 mags
https://www.ebay.com/itm/RangeTray-...dLoader-for-the-Hi-Point-995-9mm/253126668050
here is how it works
below is the review I left on there ebay product page
I was pretty skeptical that this would work bit it really does work slick. Its not the fastest but is the easiest on the hands of any mag loader I've used. This works on my Hi Point 995, Ruger LC9s, and 9mm 1911 mags so great value. It is 3d printed and the material looks like PC-ABS. Only thing that could improve it is if it was about .060" longer or so. With bullet loaded long you have to rock the mag slightly as you push it down to clear the feed lips with the 995 and 1911 mags