Before I had a reloading room, I screwed/bolted my press and powder measure to a scrap piece of 3/4" MDF and just clamped it to a table when I wanted to use it and then unclamped it and stashed it out of the way when I was done. Just keep the bottom of the board and the table clean when you clamp. No dents or scratches on the table will help to keep you in the good graces of your S/O.
My case trimmer was (and still is) screwed to a small block of wood that I clamped into a portable vice that I picked up at an estate sale for a buck. Again, pad it before you tighten the clamp on the vice.
I hope that helps with your space issue.
My case trimmer was (and still is) screwed to a small block of wood that I clamped into a portable vice that I picked up at an estate sale for a buck. Again, pad it before you tighten the clamp on the vice.
I hope that helps with your space issue.