RNB65
Member
I just had a Jard varmint trigger installed in my 700. After a couple of trips to the range, it started having a problem with not resetting the trigger after firing about half the time. I have to manually pull the trigger with the bolt open to get it to reset to the firing position. I sent an e-mail to Jard describing the problem and they sent the following response --
Can someone translate this into English for me? Where is this disconnect screw located and how do I adjust it? I'm familiar with the sear engagement, overtravel, and trigger weight screws but I've never heard of a disconnect screw.
Thanks.
It sounds like the disconnect needs to be adjusted. Back it off by turning it
counter-clock wise. When you turn it, turn it just 2 degrees at a time. If you
still have a problem, please let us know. Thanks!
Can someone translate this into English for me? Where is this disconnect screw located and how do I adjust it? I'm familiar with the sear engagement, overtravel, and trigger weight screws but I've never heard of a disconnect screw.
Thanks.