wow6599
Member
SA custom shop has my RO for a little work. They have tweaked a few things under waranty, but told me today I would have to pay $45 for the slide to be re-parked.......kind of surprised, but oh well. I had already enclosed a check for a gold bead front sight to be installed while they had it, so after the phone call, and weeks added on at this point, I decided to do a couple of other things.
The trigger will be taken down to 3.5# and the rear sight will be worked over. I was going to swap out the stock adj sight for a Harrison fixed, but the CS guy suggested getting it dehorned. I agreed and asked that they also cut it out from .125 to .140. Gold bead front and .140 rear adjustable that won't cut like a knife.
Looking for opinions on my decision, anyone who has a similar set-up, etc.
Also kind of mad at myself that I forgot to ask about the width of the front sights they use.........guessing it's .125? The stock rear (.125) and thin black front was really hard for me to use.
p.s. - $40 for dehorning and widening the rear, $80 for the gold bead front and $100 for the trigger/action job........not too bad I suppose.
The trigger will be taken down to 3.5# and the rear sight will be worked over. I was going to swap out the stock adj sight for a Harrison fixed, but the CS guy suggested getting it dehorned. I agreed and asked that they also cut it out from .125 to .140. Gold bead front and .140 rear adjustable that won't cut like a knife.
Looking for opinions on my decision, anyone who has a similar set-up, etc.
Also kind of mad at myself that I forgot to ask about the width of the front sights they use.........guessing it's .125? The stock rear (.125) and thin black front was really hard for me to use.
p.s. - $40 for dehorning and widening the rear, $80 for the gold bead front and $100 for the trigger/action job........not too bad I suppose.