HelterSkelter
Member
- Joined
- Jan 4, 2011
- Messages
- 110
is there anywhere where there is a schematic for the ruger sp101 or just a revolver in general? i have googled countless terms trying to find a picture that names all the parts but i can't find one. there are many that name just a few parts but none that name them all.
i can't find the name of the pin in the middle of the ejector or the little button that pin depresses in the frame that allows the trigger and hammer to be pulled back. on my sp101 the pin is leaving a long scratch in the frame and is denting the little button. i pressed the pin in with my finger and it seems to give too much resistance. i was going to remove the ejector and cut a coil or two of the spring that pushes this pin but i don't have the tools. i have heard from some people that this is normal for a sp101 but they said the same for the ejector rod rattling and ruger fixed that for me when i mailed it in and not a single other one of my revolvers has a gouge in the frame from this pin.
what do i do/ what are these parts names?!?!
i can't find the name of the pin in the middle of the ejector or the little button that pin depresses in the frame that allows the trigger and hammer to be pulled back. on my sp101 the pin is leaving a long scratch in the frame and is denting the little button. i pressed the pin in with my finger and it seems to give too much resistance. i was going to remove the ejector and cut a coil or two of the spring that pushes this pin but i don't have the tools. i have heard from some people that this is normal for a sp101 but they said the same for the ejector rod rattling and ruger fixed that for me when i mailed it in and not a single other one of my revolvers has a gouge in the frame from this pin.
what do i do/ what are these parts names?!?!