saltydog452
Member
- Joined
- Aug 1, 2004
- Messages
- 1,707
A little dirvergent perhaps, but...
you mentioned a couple of 'machined steel extractors...snapped in half in the middle of a Series 80 cutout...whatever support was offered by the plunger...Colt OEM...etc...'.
For Series 80 owners, would you have any recommendations for replacement extractors a little less likely to snap in half? Or should I have asked this question in a different thread?
Thanx,
salty.
you mentioned a couple of 'machined steel extractors...snapped in half in the middle of a Series 80 cutout...whatever support was offered by the plunger...Colt OEM...etc...'.
For Series 80 owners, would you have any recommendations for replacement extractors a little less likely to snap in half? Or should I have asked this question in a different thread?
Thanx,
salty.