While they aren’t exactly growing on trees you can get used 650’s loaded out pretty good for under $800 if you look around…granted you have to jump when they come up, but they are out there for that price. Couple months back there was one listed on a site that for the life of me I cannot remember for $750, casefeeder, extra toolheads, some dies, stand, roller handle and some other stuff…I almost purchased but don’t need three and since reading this thread I’ve been trying to remember where I spotted it and I’m drawing a blank. Others have mentioned getting the 750 then the casefeeder later, not sure I’d do that as the 750 w/o the feeder is a very expensive 550…save the money and get both. I loaded 3k worth of 9mm in March in just under 3 hrs and that wasn’t even going fast…the press just runs. Bunch of stuff I’d skip on purchasing as over 40 years of loading, I’ve realized they do not add anything to the process and in some cases add time or additional steps, but that’s my opinion. Good luck.