deadeye dick
Member
Just got a .45ACP conversion cyl. for my .45 LC Cattleman II. Big problem, it doesn't fit the frame. I am laid up with a broken foot so i haven't had a chance to measure anything up. When i try to slide the new cyl. in place the nub (for lack of another word) on the front of the cyl. where the base pin goes thru, hits the frame. By eye it is longer than the original. Is this standard for a replacement cyl.? Does it have to be tuned to this particular guns frame? I was thinking of stoning it down till it fit but will this interfere with any headspacing issues?
I should be able to hobble to my shop in a few days to measure everything up. Any help would be appreciated.
I should be able to hobble to my shop in a few days to measure everything up. Any help would be appreciated.