wanted-9MM loads for 125 grain cast bullets

[Phoinex]

Hi guys,
hey, I just bought a 6 cavity lee bullet mold for my Browning HP 9 mm. The bullet is a 125 grain trunciated cone - tumble lube design. My question is, does anyone have some pet loads for for thier 9 mm using a cast 125 grain bullet?
I am trying to settle on a powder and I am looking for a nice feeling load, clean burning and accurate. I am planning on using most of them for IDPA but please share if you have a bowling pin load as well.
I would like to hear about your loads and experiances with them.
Many thanks.

 

[evan price]

4+ gr of Titegroup.

 

[Walkalong]

W-231, or AA #5 if you want more velocity.

 

[KaiserBen]

I use 6.0gr of AA#5 behind a 125 LRN for my 9mm load.

 

[rbernie]

I use 4gr of Unique, and am very happy with the load.

 

[Phoinex]

Thank you

Thanks guys, I appreciate your time. My bullet mold arrived yesterday and today I broke it in and cranked out 400 bullets. They are lubed and ready to load. I can't wait to make some up and head to range to see the results.

Have fun out there, and thanks again.

 

[armoredman]

I use AA#7 in mine, a light load of 6.4 grains works pretty good in my CZ PO1, at 1.095 OAL, but I am still experimenting. got some testers loaded over AA#5, and a slightly longer OAL. That's the Lee TL 345 124 2R, the round nose tumble lube design. Works well in both 9mm and 38 Special, as it drops at .360.

 

[trickyasafox]

I'm with rbernie- I like nice light loads/

 

[ArchAngelCD]

Phoinex,
Welcome to the forum...

I load 125gr Cast bullets for my son's 9mm and his favorite load is 4.0gr W231 with a COL of 1.125". It's a great practice round and cheap to build too.