Boomholzer
Member
- Joined
- Jun 4, 2021
- Messages
- 231
Me? Two old RCBS cast aluminum hand priming tools. Loading the tray and swapping shell holders has always been a relative PITA and it also doesn't work with Hornady shell holders where I have a acquired an odd mix. Hornady didn't mill that little chamfer in the bottom side hole like RCBS.
It's the weakest link in my process and equipment. It's time for something better. Any recommendations? I run three RCBS RC presses and a T-7, nothing progressive, no blue. I have a frikken Giraud power trimmer and I still fight these priming tools.
It's the weakest link in my process and equipment. It's time for something better. Any recommendations? I run three RCBS RC presses and a T-7, nothing progressive, no blue. I have a frikken Giraud power trimmer and I still fight these priming tools.