Ash
Member
I had a 10mm Witness and liked it fine. It had a square-slide and I sold it only because I have no more 10mm's and never warmed up to the caliber.
"EAA says that particular crack is not really a problem,"
Oh boy - that's a new one!
The meat there is just very thin and I think sliding full mags into the well causes the crack there
I now have a new 10mm full size frame, the slide is much beefier on this one but I still installed a 20# Wolff spring, it makes it a little hard to rack but it's worth it.
Seer792 said:I now have a new 10mm full size frame, the slide is much beefier on this one but I still installed a 20# Wolff spring, it makes it a little hard to rack but it's worth it.
Just amazing, my whole family shoots Witness Match and Limited pistols in competition, over the last four years and 30,000 rounds not nary a prob
1) Do I want a striker fired pistol, or a DA/SA hammer fired pistol,
2) Do I want a manual safety?
3) Does the pistol fit my hand?
I just got mine. Need to add a front fiber sight at some point.
The slide issue was tracked down to a bad batch of steel that EAA used to manufacture slides a few years ago...
A real jerk or two works at EAA in key positions (or did work there), and has/have done more damage to that company than they will ever understand. I like their guns, but not the company.