Actually what I would do instead of a nut is use a piece of steel rod or tube. Tap it to the appropriate thread size. Then drill a hole in the aluminum block and press-fit the new "nut" and adhere with anerobic adhesive. That way you only have to drill a round hole to fit the nut.
LOL. Actually I prefer "Mk I sensor."
Agreed on the questionable quality of Auto Ordnance slides. Very soft steel; on all other 1911s, the slide is harder than the frame.
PS: I have a new, uncut STI slide. Yours cheap if you want it. Drop me email or PM.
Contrary to popular belief, there are more differences in the "Lady" K than just a lighter recoil spring. The striker spring is also lighter and the striker bore is honed. Sear is also different, but I'm not exactly sure what makes it different.
I think the real issue at hand is getting the bore hot enough to anneal the steel. Well, it doesn't take much with magnum loads. Probably two shots per minute before the process starts. Shouldn't affect accuracy, but the barrel's life expectancy will be shorter.
Ah, good job on the DIY. I had this same problem but purchased a small copper washer to seal it. IIRC, I bought it from smallparts.com; only ordered one because they weren't as cheap as I was hoping. You might be able to find a suitable washer either from an auto parts store or from a...
That should probably read "14 REPORTED unintentional discharges..." You can probably Google for five minutes and find more than 14 newspaper articles of negligent discharges.
One night a couple years ago I heard a park ranger scream "SHOTS FIRED!!" on my scanner radio. The police came, full...
I find that the roll pin punch will get you into a lot of trouble when installing pins. They tend to work into the pin and spread it open. I usually get them started with a flat brass punch and when it's 90% in, drive it home with the roll pin punch. LIGHTLY. If you go too hard then the...
I use the .45ACP +P load (red box). It doesn't seem as hot as Remington Golden Sabre .45ACP +P in terms of muzzle flash. The Remingtons throw a HUGE fireball.
The Hornady's bullets are total metal jacket. I have confirmed this by digging some out of the mound I was shooting at.
Hah, cool ad.
I blew my gun money on guns and a diamond ring for the wife as a Christmas gift. So that means no scope for the new TRG-22 for the next few months.
As to the XD, I'd have to wait for it to hit the California DOJ list before buying one. For 2006 all the newly added handguns...
Getting those little circles evenly spaced can be a tough job!!
The only way I've managed to get a job that looks perfect is to use a cross slide vise as dfariswheel has suggested. (Actually I use a mill, but the end result is about the same.)
Securely mount a dial indicator and use it to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.