Search results for query: *

any rk shows where you live,?

no tire stores in my part of tn, will sell you any wheel weights anymore.

the 64's around here go for around 600.00. 442's around 400.00. at shows, knoxville tn.

everyone tells me the stock glock 10mm isn't ramped.

im in tn near the cherokee capitol, choto, though they aren't the ones who used flint arrowheads, they are a lot older. woods indians and back, i collect, and make them too. there are several knapp ins around here.

have you tried numrich arms?

500-.45acp 600-9mm 1200-10mm 100-.357 150-.38 coffee can full of .22 components for lots more centerfires.

i had that problem with one of those about that time,70's, best i remember the firing pin hole through the frame was too small and wouldn't let the pin fall through easy enough.

all these 10guys and i can't get an answer about why some are ramped, some not, some both on the same model? (cbob)

you take a big chunk of flint and whack in with antler or (modern way),a piece of copper pipe full of lead with the end cap rounded out.spall, once you get a rough arrowhead shape, take a sharp antler (copper rod modern) and pressure chip flakes to make an arrowhead.knapp.

in the last pic of the 38 super on the right, my un-ramped dan has that much support, shows about that much case on bottom.

i keep a fubus holster zip tied to a slat under the bottom mattress fondation ,(have to cut the cloth on bottom, just a few slits) positioned so i can just roll over and reach it without even getting ouy from under the covers, (no kids), other than while sleeping i always just carry something.

i like berrys plated bullets

don't mean to hi=jack this thread, but there is a lot of confusion on this. might help somebody decide on a purchase. if i had known earlier, the guy would still have his cbob and i would still have my 1200.00

what i meant was the part of the brass between the solid head and the back of the barrel was a 32nd best i could measure.maby just a hair less but no more. probably didn't make any sense. if the head was a tad thicker it would have no un supported area of the thin wall,, i tried to take pics but...

gunny guy i just cut a starline 10mm in half and measured the un-supported area on my cbob. it had a thirty seconths of an inch unsupported in the throated area,bottom half. safe to shoot with heavy loads? double tap ammo.

never owned one but i don't *think* the glock is supported

i KNOW what ramped or not IS, that was not my question, the delta shown is NOT ramped, just like my 07 cbob. i just want to know why dan/cz went from un ramped to ramped mid stream, even the ramped barrels have some cut out under the cartridge too.

cbob's weren't ramped before 08, mines not. same set up as a colt 1911 .45. i've yet to find anyone that can tell my why beyond, well its just stronger.

you haven't lived till you shoot a new gun and feel something hit you in the head then feel something running down your face. no not a taurus either. i bought the first naa .22 i saw. went to shoot it and it sprayed my hand and forehead with lead. went back to the house and picked all the...