Search results for query: *

I have a new rifle with a Bell & Carlson stock.I want to repaint the stock,but the current finish has a texture that will take a lot of work to sand down.It looks like a textured paint,and scrapes off,so I am thinking I may be able to use a commercial stripper to remove it.I am concerned...

It looks like I will be leaving Commyrado for Columbia,South Carolina,and would like to continue pursuing my interest in long range shooting. I'm looking for a 500 yard or longer range within a couple hour drive. Anyone know a good range in the area?

I'm sure it has been asked before,but can someone help me understand the laws concerning carbine kits? Several years back I picked up a carbine stock set in a trade,but I only have pistol barrels.I haven't used the stock on my receiver,because I have no barrel in carbine or rifle length.I was...

I am in the process of moving to Denver,and need a good range.Prefer a private club with at least a 300 yard rifle range.Buffalo Creek out by Bailey looks like a pretty good setup;anyone else have any ideas?

I would like to rechamber a 357 Herrett barrel to .357-.444. I've been searching with no luck for a reamer.I know SSK will do the the work (358 JDJ),but I would like to do it myself.It would be great to rent the reamer to keep the cost down,but I figure the chances are slim.Does anyone have any...

I dislike case trimming as much as anyone.Do these dies work as advertised?Thinking about picking up a set,and would like some feedback. Thanks all.

I must be on a roll thus year.I applied for a highly coveted Nebraska bull elk this year for the first time,and drew one.Yesterday morning,after only two hours in the woods,I had my first bull ever on the ground.And what a bull he was!A 6 x 7 estimated by people with a lot more experience than...

Sometimes,it seems my luck only gets worse.But every now and then I get thrown a bone.This June I applied for the first time,and was awarded a Nebraska bull elk tag.This is a once in a lifetime tag!My father in law,brother in law,and other friends have been applying for years,and getting...

anybody ever do a trigger job on a howa,weatherby vanguard,ect? i would rather not buy an aftermarket unit if i can do the work myself.i have played with the adjustment screws several times,but the trigger still stinks.any ideas?

anyone have a good load for 100 gr tsx in a .257 weatherby? how about the varmit grenades in a .218 bee? don't have the barnes manual yet,but i know the .218 isnt in it.

dug to the back of the safe and rediscovered my old winchester m-100. i havent shot it for years,looking for 150 or 165 gr.load suggestions.being gas operated,i know some powders are not recomended due to pressure curves being wrong.dont want to damage the old girl.any ideas?