So i'm attempting to bump the neck on my once fired 300 win mag brass. I tried to seat the empty case into the rifle and it was tough fit, i had to push the bolt pretty hard to get it to close. So then i set Lee FL die just low enough to deprime and kept adjusting and fitting and adjusting.
I have 2 issues: First is when i forced the bolt closed it put a very small dent just below the shoulder. I figured bumping the shoulder would take this dent out but it hasn't so far. Should I keep adjusting? Second, i've adjusted down to the point where i'm pretty close but not quite touching the shell plate with the body of the die. Should I keep adjusting?
Need some opinions on what to do...
I have 2 issues: First is when i forced the bolt closed it put a very small dent just below the shoulder. I figured bumping the shoulder would take this dent out but it hasn't so far. Should I keep adjusting? Second, i've adjusted down to the point where i'm pretty close but not quite touching the shell plate with the body of the die. Should I keep adjusting?
Need some opinions on what to do...