Hey Folks,
I loaded up a couple hundred rounds today and noticed a few rounds with set back.
After checking all two hundred I was able to push 24 of the bullets into the case by pushing the micrometer.
After taking a few apart, the bullets were measuring as low as .0395.
I gather this is the problem - what is the minimum a 40 cal. should measure?
These are 180gr Cam-pro. I have loaded 1000's and never had an issue until now.
Should I measure each round at the case mouth or take all of them apart and not chance it?
Any guidance would be appreciated.
Thank you,
I loaded up a couple hundred rounds today and noticed a few rounds with set back.
After checking all two hundred I was able to push 24 of the bullets into the case by pushing the micrometer.
After taking a few apart, the bullets were measuring as low as .0395.
I gather this is the problem - what is the minimum a 40 cal. should measure?
These are 180gr Cam-pro. I have loaded 1000's and never had an issue until now.
Should I measure each round at the case mouth or take all of them apart and not chance it?
Any guidance would be appreciated.
Thank you,