Shoot The Moon
Member
Gents, (apologies if this has been covered before, I ran two searches to no avail) I've been examining my Euroarms Remington and have noticed that the cylinder stop (bolt if you prefer) is raising quite early. This does not affect the function of the revolver but does not seem correct and it is marring the cylinder.
I'm interested in other folks opinion on this - should I try to correct it or is it of no consequence? If I should try to correct the timing, how? Looking at the action it's not immediately obvious, although at a guess, the hand is too short?
Any advice welcome!
I'm interested in other folks opinion on this - should I try to correct it or is it of no consequence? If I should try to correct the timing, how? Looking at the action it's not immediately obvious, although at a guess, the hand is too short?
Any advice welcome!