Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

AR Build, Minor Problem - Stock Wrench

Discussion in 'Rifle Country' started by TrafficMan, Oct 17, 2008.

Thread Status:
Not open for further replies.
  1. TrafficMan

    TrafficMan Member

    Joined:
    Oct 17, 2005
    Messages:
    263
    I ordered a Stock Wrench for my AR build from Midway. Got the stock from Gunbroker, just a standard M4 Collapsible...

    The stock wrench doesn't fit correctly into the castle nut on the stock. Appears that the notches on the Castle Nut are too small for the wrench. Is this a common issue? I suppose I could just file down the wrench to make it work, but I would appreciate some input before I do that.

    Thanks In Advance.

    Scott
     
  2. ArmedBear

    ArmedBear Member

    Joined:
    Sep 8, 2005
    Messages:
    23,171
    Hmmm...

    My stock wrench fit, but I got it from Brownell's and the stock from Cavalry.

    Are you sure it's "standard"?

    You could also swap out the castle nut with a standard one, or file the notches bigger.
     
  3. Rubber_Duck

    Rubber_Duck Member

    Joined:
    May 26, 2008
    Messages:
    1,357
    Location:
    New Mexico
Thread Status:
Not open for further replies.

Share This Page