jmorris
Member
- Joined
- Sep 30, 2005
- Messages
- 24,297
I have been looking into setting up a bullet plating operation but ran across a thread on coating over at castboolits and thought I would give it a try as it is pretty simple and fast.
My coating chamber was built by making a few cuts in a used beer box. HF powder coater and a bottle of powder was $64 and $20 for a toaster oven off of Craigslist.
Put some 8-32 nuts on the pan kind of spread out and laid foil over them. This raises the base so it's not sitting in the liquid that forms from the powder.
Heat the bullets so they are warm then connect the PC lead to the pan and spray the powder on.
Heat at 400 for 15 min and open the door and let them cool slowly.
Then load up and shoot. At least that's what I did this afternoon. They grew about .001" but I didn't waist any time resizing the one I shot to see how the coating held up, didn't want to be looking for a bullet at the bottom of my pool after dark.
My coating chamber was built by making a few cuts in a used beer box. HF powder coater and a bottle of powder was $64 and $20 for a toaster oven off of Craigslist.
Put some 8-32 nuts on the pan kind of spread out and laid foil over them. This raises the base so it's not sitting in the liquid that forms from the powder.
Heat the bullets so they are warm then connect the PC lead to the pan and spray the powder on.
Heat at 400 for 15 min and open the door and let them cool slowly.
Then load up and shoot. At least that's what I did this afternoon. They grew about .001" but I didn't waist any time resizing the one I shot to see how the coating held up, didn't want to be looking for a bullet at the bottom of my pool after dark.