This is basically a double-check on my math. I have a flat-top AR that I've been thinking about putting some glass on it.
The scope I'm thinking about is a budget model, as my AR is mostly for punching paper, and it's not set up for precision shooting. http://www.midwayusa.com/viewProduct/?productnumber=510964 The long and short is, I want a scope.
Simmons, 46.7 mm objective, 1" tube.
I've been reading here: http://www.thehighroad.org/showthread.php?t=524620
And the rule of thumb I'm seeing is to mount the scope about 1.4" to 1.5" above the rail from the center of the scope. Running the numbers for a 1" tube and a 1.5" height, I would want a pair of rings that had a ring-base to bottom of tube right at 1".
So http://www.midwayusa.com/viewProduct/?productNumber=810257 ?
The scope I'm thinking about is a budget model, as my AR is mostly for punching paper, and it's not set up for precision shooting. http://www.midwayusa.com/viewProduct/?productnumber=510964 The long and short is, I want a scope.
Simmons, 46.7 mm objective, 1" tube.
I've been reading here: http://www.thehighroad.org/showthread.php?t=524620
And the rule of thumb I'm seeing is to mount the scope about 1.4" to 1.5" above the rail from the center of the scope. Running the numbers for a 1" tube and a 1.5" height, I would want a pair of rings that had a ring-base to bottom of tube right at 1".
So http://www.midwayusa.com/viewProduct/?productNumber=810257 ?