Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Could a Gunsite Scout Rifle owner please help me with some dimensions?

Discussion in 'Rifle Country' started by axxxel, Jan 26, 2012.

Thread Status:
Not open for further replies.
  1. axxxel

    axxxel Member

    Joined:
    Feb 23, 2009
    Messages:
    236
    Hello,

    I'm in need of some dimensions for a project I'm considering. It would be very helpful to me if someone out there on the interwebs could measure his or her Ruger GSR polymer magazine and post the outer dimensions.

    Basically, I'm looking for the width and length of the rectangle that is the profile of the magazine if you view it from above (feed lips visible).

    Big thanks to anyone who posts info.

    I'm also curious about the older ruger magazines, the steel ones.
     
  2. MichaelB

    MichaelB Member

    Joined:
    May 27, 2004
    Messages:
    33
    Location:
    Vancouver, WA
    Measured with dial caliper.
    Ruger steel magazine:
    length front to rear:3.042"
    Width in front: 0.855
    Width in center: 0.740
    Width in rear: 0.965

    Ruger poly:
    Length front to rear: 3.40
    Width at front: 0.845
    Width at center: 0.875
    Width at rear: 0.960

    HTH,
    Mike
     
  3. axxxel

    axxxel Member

    Joined:
    Feb 23, 2009
    Messages:
    236
    Super!

    Thank you
     
  4. axxxel

    axxxel Member

    Joined:
    Feb 23, 2009
    Messages:
    236
    MichaelB's post gave me a new question... Where can I buy one?

    I've checked midway, ImpactGuns and Brownells, and none of them is currently doing international shipping. I know US export laws are crazy but I think 10 round bolt action mags should be ok.

    I also checked cheaperthandirt. What are the other big online stores? Thank you.
     
Thread Status:
Not open for further replies.

Share This Page