psychbiker
Member
- Joined
- Apr 30, 2011
- Messages
- 10
So I don't like the stock LnL handle. I didn't want to bend it. I couldn't find a 5/8-18 die so I found 5/8-18 all thread.
What do you think? The roller part is just 3/4 brass pipe. It spins freely.
I think it's overall too long. It seems to hand past the press more than the InlineFab one or others Ive seen. I can screw it more into the press and then bend up on the handle, that should help. It was $12 including 4 5/8s nuts, so getting another piece isn't a big deal. Beats $55 for the new ones. Plan on painting it black or finding 1/2 heat shrink tubing to go over the whole thing rod when I'm done
What's the length in total for those with the inlinefabrication handles?
Here's a screen shot of them side by side, mines not too bad. Needs a little tweaking.
What do you think? The roller part is just 3/4 brass pipe. It spins freely.
I think it's overall too long. It seems to hand past the press more than the InlineFab one or others Ive seen. I can screw it more into the press and then bend up on the handle, that should help. It was $12 including 4 5/8s nuts, so getting another piece isn't a big deal. Beats $55 for the new ones. Plan on painting it black or finding 1/2 heat shrink tubing to go over the whole thing rod when I'm done
What's the length in total for those with the inlinefabrication handles?
Here's a screen shot of them side by side, mines not too bad. Needs a little tweaking.
Last edited: