I didn't say Kimber MIM parts were good, just that they made their own. Yes, they are a CMC design but Kimber makes their own parts.
The frame and slide "Forgings" come from S&W which are some of the best and then milled in house. DW uses the same " Forgings" on there upper end guns but the lower end guns including the Panther uses Essex CAST frames and slide or just the frame.
Bob himself admitted using "masson" mag releases after they were breaking.
Go ahead and slam the Brenster but it was I who got DW to stop putting huge logo's all over their guns and to offer no front serrations, rear sights that can move for windage and so on.
Most of "BREN" has been stricken from the record do to people that can't handle a straight talker. The board erases thead after some time so the PROOF AND FACTS are all but gone.
But at the top of the board is a hint from days gone by.
Heres a quote,, (Facts?)
DanWesson_Rep
Moderator
Registered: Oct 2002
Location: Norwich NY
Posts: 530
Request for artwork
Here is your chance to participate directly. As we get started with a custom shop (if that is even what we should call it), we are going to need a logo. We want to be subtle, and people like ***Bren**** have already convinced us to tone down the lasering, so help us come up with a classy logo or lasering package to put on these guns.
So we are going to throw it out to the forum and take suggestions. Draw something up and submit it and we will either select a design or modify one and adopt it. Kind of cool because this stuff will end up in magazines and at the SHOT Show and such.
I guess jpg format or bmp would be nice but I think I can work with most anything. So get thinking and over the next few weeks lets see if we can't make a selection.
__________________
Phil
There ARE people out there that know the truth . Bren