Where can you buy that copper lube at?? I just got a NIB G30 and
it didn't have any copper lube at all on it ... it is as dry as the desert sands !!!
I haven't shot it yet, and I might as well ask while I'm here "should I lube it up a little bit before I shoot it for the first time since Glock cheeped out on the factory lube-job?" What the heck is up with that?? Must ah been assembled on a Friday
It also has the new-er 4256-1- TB. I've racked the slide a few time and the TB on the lower left angled edge has a scuff on it. It doesn't seem to be hanging up any but was thinking of lightly ... very very very lightly... hitting the beveled edge with some 1000 grit w&d sand paper to smooth it a bit??? Or would it be suggested I just lube it up and shoot a few rounds and see how she does?
Oh ... and a nickel slides through the front rails with a very slight clearance but with the back rails at first it didn't go through but after a few passes it now does but it's a tight fit. The rear rails also seem a bit lower then the front too.
Would you in the know advise I leave the rails be or run a very fine emery board through them and if so ... take a very very very little bit of plastic off the frame or metal off the rail?
Again ... Keep in mind it's new and hasn't been fired yet.